AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Rms alarm dmg mori online4/30/2023 ![]() ![]() ![]() That being said, it may be a drawbar issue, not releasing the tool completely and the arm fighting it, which would explain why it works in manual mode. The only alarm it throws is EX0159 (ATC ARM H.P. ![]() My techs and I are pretty much all out of ideas on where to look next. So far weve tested, checked, and found that all the following are good: -Motor -Piston Assembly on top with cam follower -Both sensors -Contactor in electrical cabinet -Hydraulic solenoid block that controls tool clampunclamp during ATC Cycle -Cam followers inside the ATC and all associated roller bearings -Gears all look good inside ATC. Manual tool changes (TM6 method) work fine as well as using the ATC MANUAL OPERATION in the Custom menu. This usually happens anywhere from the first tool change in the program, to after 4 hours of production. It will begin the cycle, get partway through, then just stop and bounce a bit. Intermittently it will not complete the ATC cycle, not always on the same tools. ![]()
0 Comments
Read More
Leave a Reply. |